Kyocera DP-480

2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-3-76
Method: [All]
1. Load A4/letter paper.
2. Press the start key to output the original for adjustment.
3. Set the output the original for adjustment and press the start key.
4. Set the output the original for adjustment on the DP face up.
5. Press the start key to scan documents.
6. Press the start key. Auto adjustment of first side starts.
7. Set the output the original for adjustment on the DP face down.
8. Press the start key to scan documents.
9. Press the start key. Auto adjustment of second side starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem occurs
during auto adjustment, error code is displayed and operation stops. Should this happen,
determine the details of the problem and repeat the procedure from the beginning.
Error Codes
Codes Description
01 Automatic adjustment success
03 Black band detection error (scanner leading edge registration)
03 Black band detection error (scanner main scanning direction magnifica-
tion)
04 Black band is not detected (scanner leading edge registration)
05 Black band is not detected (scanner center line)
06 Black band is not detected (scanner main scanning direction magnifica-
tion)
07 Black band is not detected (scanner auxiliary scanning direction magnifi-
cation)
08 Black band is not detected (DP main scanning direction magnification far
end)
09 Black band is not detected (DP main scanning direction magnification
near end)
0a Black band is not detected (DP auxiliary scanning direction magnification
leading edge)
0b Black band is not detected (DP auxiliary scanning direction magnification
leading edge original check)
0c Black band is not detected (DP auxiliary scanning direction trailing edge)
0d White band is not detected (DP auxiliary scanning direction trailing edge
2)
0e DMA time out
0f Auxiliary scanning direction magnification error
10 Auxiliary scanning direction leading edge detection error
11 Auxiliary scanning direction trailing edge detection error
12 Auxiliary scanning direction skew 1.5 error
13 Maintenance request error
14 Main scanning direction center line error
15 Main scanning direction skew 1.5 error