Kyocera DP-480

2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-5-100
(2) Detaching and refitting the PF feed clutch
Procedure
1. Remove the stop ring and the bushing.
2. Remove three screws and grounding
terminal.
3. Remove the motor mount frame.
Figure 1-5-174
4. Remove the connector from the PF
paper feed clutch.
5. Pull out the PF paper feed clutch.
6. Check or replace the PF feed clutch
and refit all the removed parts.
Figure 1-5-175
Stop ring
Bushing
Screw
Screw
Screw
Grounding
terminal
Motor mount frame
PF paper feed clutch
Connector