2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-4-83
(15) Unevenly repeating horizontal streaks in the printed objects. Spots in the printed
objects.
Print example Cause of trouble
1. Installation at a high altitude.
2. Using the paper with high surface resistance.
Defective part Check description Corrective Action
1
Developer unit The device is installed in an
altitude higher than 1500 m sea
level.
If the device is installed in an altitude greater
than 1500 m sea level, perform the following.
2
Paper Check if paper is of high surface
resistance.
Change the paper to another.
To Next Page
Loading...
