Kyocera DP-480

2NC/2NF/2NG/2NN/3P7/3P8/3P9-2
1-3-26
5. Change the setting value using change keys * or numeric keys.
* : Zoom/Paper selection key (Basic model), Right/Left arrow key (Advanced model)
For output example 1, increase the value. For output example 2, decrease the value.
6. Press the start key. The value is set.
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following
adjustments in maintenance mode.
U034 -------- U067 -------- U072
(P.1-3-34) (P.1-3-39)
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Center line of printing
(within ± 2.0 mm)
Correct image
Output
example 1
Output
example 2
A feed setup is performed as follws.
Select item Feed Paper type Duplex mode
LSU Out Top :MTP MP Tray Plain OFF
LSU Out Top :Cas1 Cassette1 Plain OFF
LSU Out Top :Cas2 Cassette2 Plain OFF
LSU Out Top :Cas3 Cassette3 Plain OFF
LSU Out Top :Cas4 Cassette4 Plain OFF
LSU Out Top :Duplex Cassette1 Plain ON
LSU Out Left :MTP MP Tray Plain OFF
LSU Out Left :Cas1 Cassette1 Plain OFF
LSU Out Left :Cas2 Cassette2 Plain OFF
LSU Out Left :Cas3 Cassette3 Plain OFF
LSU Out Left :Cas4 Cassette4 Plain OFF
LSU Out Left :Duplex Cassette1 Plain ON