Kyocera DP-480

2NC/2NF/2NG/2NN/3P7/3P8/3P9
2-2-4
(3) Connector lists
Connector Pin Signal I/O Voltage Description
YC1
1
SCANNER_B-
O 0/24 V DC(pulse) ISUM drive control signal
Connected to
scanner
motor
2
SCANNER_B
O 0/24 V DC(pulse) ISUM drive control signal
3
SCANNER_A
O 0/24 V DC(pulse) ISUM drive control signal
4
SCANNER_A-
O 0/24 V DC(pulse) ISUM drive control signal
5 NC - - Not used
YC2
1 DU B- O 0/24 V DC(pulse) DUM drive control signal
Connected to
duplex motor
2 DU B O 0/24 V DC(pulse) DUM drive control signal
3 DU A O 0/24 V DC(pulse) DUM drive control signal
4 DU A- O 0/24 V DC(pulse) DUM drive control signal
YC3
1GND
- - Ground
Connected to
high voltage
PWB
2 SISEL
O Analog Separation DC shift signal
3SREM
O 0/3.3 V DC Separation DC: On/Off
4 MISENS
I Analog Charging current detection signal
5MCNT
O 0/3.3 V DC(pulse) Charging DC control signal
6TCNT
O 0/3.3 V DC(pulse) Transfer DC control signal
7TREM
O 0/3.3 V DC Transfer DC: On/Off
8 DBDCCNT
O 0/3.3 V DC(pulse) Developer DC shift signal
9DBCLK
O 0/3.3 V DC(pulse) Developer AC clock signal
10 +24VIL
O 24 V DC 24 V DC power output to HVU
YC4
1 FEED_CL_RE
M
O 0/24 V DC PFCL:On/Off
Connected to
paper fed
clutch, regis-
tration clutch,
MPF sole-
noid, main
motor
2+24V4
O 24 V DC 24 V DC power output to PFCL
3 REG_CL_RE
M
O 0/24 V DC RCL: On/Off
4+24V4
O 24 V DC 24 V DC power output to RCL
5 MPF_SOL_R
EM
O 0/24 V DC MPSOL: On/Off
6+24V4
O 24 V DC 24 V DC power output to MPSOL
7 MAIN_READY
I 0/3.3 V DC MM ready signal
8 MAIN_CLK
O 0/3.3 V DC(pulse) MM clock signal
9 MAIN_REM
O 0/3.3 V DC MM: On/Off
10 GND
- - Ground
11 +24VIL
O 24 V DC 24 V DC power output to MM