Kyocera DP-480

2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-5-90
(1-3) Detaching and refitting the DP ragistration clutch
Procedure
1. Release the wires from the wire guide.
2. Pull two projections of the wire guide
forward.
3. Remove the wire guide by unhooking
six hooks by sliding downward.
Figure 1-5-158
4. Remove the connector from the regis-
tration clutch.
5. Remove the stop ring.
6. Pull out the DP registration clutch for-
wards.
7. Check or replace the DP registration
clutch and refit all the removed parts.
Figure 1-5-159
Wire guide (Back side)
Projection
Hooks
Projection
Wire guide
Stop ring
DP registration clutch
DP
Connector