2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-4-85
(17) The leading edge of the image is consistently misaligned with the original.
Print example Cause of trouble
1. Improperly adjusted leading edge timing.
2. Improper amount of slack of the original document in front of the registration.
Defective part Check description Corrective Action
1
Regist roller 1. Check whether the leading-
edge timing is adequately
adjusted.
If theadjustment is not sufficient, execute U034
to adjust the leading edge timing. (see page 1-
3-24)
2. Check whether the amount
of slack of the original
document when it reaches at
the DP regist is adequate.
If the amount of the slack in front of the regist
roller is insufficient, execute U051 to optimize
the slack. (see page 1-3-28)
To Next Page
Loading...
