Kyocera DP-480

2NC/2NF/2NG/2NN/3P7/3P8/3P9-6
2-2-14
[NOTE]: After replacing the main/engine PWB, follow the procedures below.
In addition, print out the report if possible before replacing the main/engine PWB.
If you do not follow the procedures below, the unit might not work normally without retrieving
the original settings.
Below are the items the users set.
Since the items that are set with the system menu will be cleared, set again after confirming with the users.
No Changes and implementation Remarks Advanced Basic
1 Execute maintenance mode U004 (Machine No.)
Power switch OFF-->ON
If there is a conflict of serial
number between the main/
engine PWB, C0180 (Machine
number mismatch) appears.
OO
2 Execute maintenance mode U265 (Set Model
Dest)
OO
3 Execute maintenance mode U252 (Set Dest) O O
4 Execute maintenance mode U021 (Init memory) O
5 Set the language with system menu
[Common Setting] → [Language]
OO
6 [Only when DU is equipped]
Execute maintenance mode U211
(Set EH Connection)
OO
7 [Only when FAX is equipped]
Execute maintenance mode U600 (Init All Data)
O-
8 If there is any change from the initial setting, set
the maintenance mode again (Refer to the figures
A and B of next page).
If there is a maintenance
report, set again to the same
value.
OO
9 If there is any problem with copy image check,
execute the maintenance modes below.
-maintenance mode U034 (Adj Paper timing)
-maintenance mode U402 (Adjust margin)
-maintenance mode U411
(Scanner Auto Adjustment )
-maintenance mode U425 (Set Target)
If there is a maintenance
report, set again to the same
values.
If not, execute the adjustment.
OO
10 Execute adjust halftone with system menu O O
No Changes and implementation Remarks Advanced Basic
1 Shortcut setting OO
2 Panel program OO
3 Network setting Set again to the same value if
there is a network status page.
O-
4 Common setting Set again to the same value if
there is a status page.
OO
5 Printer setting Set again to the same value if
there is a status page.
OO