2NC/2NF/2NG/2NN/3P7/3P8/3P9-2
1-5-50
6. Remove the screw.
7. Remove the exit unit from the fuser unit.
8. Check or replace the fuser unit and refit
all the removed parts.
9. When replacing the new unit,proceed
as follows:
1)Performs maintenance mode U167
(Clr Fuser Cnt) (see page 1-3-56).
Figure 1-5-84
*: When you insert two positioning axes in
two locating holes for refitting the exit
unit, be carefully and don't changed the
grounding spring.
Figure 1-5-85
Screw
Exit unit
Fuser unit
Locating holes
Exit unit
Fuser unit
Grounding
spring
Positioning
axes
To Next Page
Loading...
