EasyManuals Logo

Labrie EXPERT Service Manual

Default Icon
425 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
90 General Maintenance
Figure 3-103
Plastic wiper blade
3. Reinstall all parts that have been removed by applying the following procedures in reverse order:
A. Removing Packer Panel - Standard Units W/ Loading Arm on page 81, A. Disconnecting Packer -
Standard Units W/ Loading Arm on page 73 and A. Accessing Packer - Standard Units W/ Loading
Arm on page 50.
4. Once finished re-assembling the removed components, lubricate and check for proper operation
of the packer.
NOTE: If the packer moves vertically by more than 3/16”, the upper wear pads must be replaced or
adjusted (see Upper Wear Pads on page 135 and Replacing and Adjusting Upper Wear Pads on
page 163).
B. Installing New Packer - Standard Units W/O Loading Arm
To install a new packer:
1. Using a lifting device, lower the new packer into the hopper, properly aligning the packer with the
floor guides.
2. Install a new wiper blade on each side of the packer (see Figure 3-104).
These wiper blades may require to be adjusted with shims to reduce the play between the blades
and the packer (see Figure 3-104 and Figure 3-257).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie EXPERT and is the answer not in the manual?

Labrie EXPERT Specifications

General IconGeneral
BrandLabrie
ModelEXPERT
CategoryTrucks
LanguageEnglish

Related product manuals