EasyManuals Logo

Labrie EXPERT Service Manual

Default Icon
425 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
38 General Maintenance
Push the floating panels, one at a time, towards the front of the vehicle. A few inches before
complete closure, pull down the sliding button to lower the panel pin in order to facilitate closure
of the panel. Make sure the pin entered the holding hole (see Figure 3-14).
Figure 3-14
Floating panel pin
19. Clean out the rest of the EXPERT™ body.
NOTE: Perform a visual inspection of the hopper area checking for possible leaks in the hydraulic
system and wear on mechanical parts.
20. Exit the hopper (if need be).
21. Using the provided hoe, rake small pieces of garbage out of the clean-out traps.
22. Clean the area with pressurized water.
23. Close both clean-out trap doors.
Danger!
Always use the handle to hold the floating panel. Holding the floating panel by its edge
will cause severe injuries to hands and/or fingers.
Caution!
When parking the truck overnight after cleaning the hopper, Labrie Enviroquip Group
recommends leaving the truck’s clean-out traps slightly open if frost is forecast in your
area. This should prevent rain accumulation at the bottom of the hopper and ice build-up
around the packer cylinders. This will also help you use the truck right away when
returning to work in the morning.
Never use the packer when its components are stuck in ice, as damage or
malfunction of said components may result.
Before each work shift make sure all clean-out trap doors are securely closed.
Pin
Holding
hole
Sliding
button

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie EXPERT and is the answer not in the manual?

Labrie EXPERT Specifications

General IconGeneral
BrandLabrie
ModelEXPERT
CategoryTrucks
LanguageEnglish

Related product manuals