Figure 148. Installing the system I/O board onto the processor board
a. Align the system I/O board with the connector on the processor board, and use both hands
to push the system I/O board and slightly insert it into the connector.
Note: To prevent the contact of the system I/O board from damage, ensure that the system I/
O board is aligned correctly with the connector on the processor board, and remains as
horizontal as possible during the insertion.
b. Install the screws to fix the system I/O board into place.
Step 4. (Optional) If you are replacing the system I/O board, install the firmware and RoT security module
that is removed from the old system I/O board onto the new system I/O board. See
“Install the
firmware and RoT security module” on page 195
.
Step 5. Install the MicroSD card (
“Install the MicroSD card” on page 137).
Step 6. Install the system board assembly into the server.
Chapter 5. Hardware replacement procedures 205
To Next Page
Loading...
