Rear backplane: 4 x 2.5-inch SAS/SATA
To connect the front backplanes, refer to “Front backplanes: 24 x 2.5-inch SAS/SATA” on page 102.
The following shows the cable connections for the 4 x 2.5-inch SAS/SATA rear backplane if installed.
From To
Backplane 4: SAS CFF expander: C3
Backplane 4: PWR Riser 1: PWR1, PWR2
Connections between connectors: 1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Figure 47. Cable routing for the 4 x 2.5-inch SAS/SATA rear backplane
Chapter 3. Internal cable routing 103
To Next Page
Loading...
