Table 21. SW8 switch block (continued)
Switch number Switch name
Description
SW8-4 Force XCC update
switch
• OFF: The switch is in default setting.
• ON: Force XClarity Controller to boot from a backup image.
SW8-5 XCC SPI0 half ROM
switch
• OFF: The switch is in default setting.
• ON: Enable low security mode for XClarity Controller
firmware (For development purpose only)
SW8-6 Low security switch • OFF: The switch is in default setting.
• ON: Enable low security mode for XClarity Controller
firmware (For development purpose only).
SW8-7
Reserved This switch is reserved for development purpose only.
SW8-8 Override power-on
password switch
• OFF: The switch is in default setting.
• ON: Override the power-on password.
Parts list
Use the parts list section to identify each of the components that are available for your server.
• “2.5-inch drive bay chassis” on page 60
• “3.5-inch drive bay chassis” on page 64
Chapter 2. Server components 59
To Next Page
Loading...
