Step 4. Install the 7mm drive backplane on the top.
Figure 279. 7mm drive backplane installation (top)
a. Align the holes in the backplane with the holes on the cage, and put the backplane down onto
the cage.
b. Install the two screws to secure the backplane in place.
After you finish
Install the 7mm drive cage onto the riser cage. See “Install the 7mm drive cage” on page 347.
Install the 7mm drive cage
Use this information to install the 7mm drive cage.
About this task
Attention:
• Read “Installation Guidelines” on page 185 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DqVplE36HIvdM_sq_Auw3U
• Youku: https://list.youku.com/albumlist/show/id_59643657.html
Procedure
Chapter 4. Hardware replacement procedures 347
To Next Page
Loading...
