Remove a power supply unit
Use this information to remove a power supply unit.
About this task
The following describes the information that you must consider when removing a power supply:
Note: If the power supply unit to be removed is the only one installed, the power supply is non-hot-swap
and before removing it, you must turn off the server first. To support redundancy mode or hot-swap, install
an additional hot-swap power supply.
Attention:
• Read “Installation Guidelines” on page 185 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DqVplE36HIvdM_sq_Auw3U
• Youku: https://list.youku.com/albumlist/show/id_59643657.html
Procedure
Chapter 4. Hardware replacement procedures 291
To Next Page
Loading...
