Appendix A. Hardware disassembling for recycle
Follow the instructions in this section to recycle components with compliance with local laws or regulations.
Disassembling the system board for recycle
Follow the instructions in this section to disassemble the system board before recycling.
About this task
Recycle the system board in compliance with local environmental, waste or disposal regulations.
Procedure
Figure 306. Disassembling the system board
Screws Qty.
Tools
9 PH2
screwdriver
5 PH1
screwdriver
12 T20 torx
screwdriver
4 7 mm
wrench
2 5 mm
wrench
1 11 mm and
16 mm
wrench
Note: The screws showed in the
illustration are marked in colors
for better to distinguish.
Step 1. Remove the system board from the server (see “Remove the system board” on page 354).
Step 2. Remove the screws as illustrated and separate the components
1 2 * 3 4 5 6 7 from the system
board.
© Copyright Lenovo 2021 415
To Next Page
Loading...
