Step 2. Remove the OCP label.
Figure 207. OCP label removal
After you finish
1. Install a new OCP 3.0 Ethernet adapter or a card filler.
2. If you are instructed to return the defective component, follow all packaging instructions and use any
packaging materials that are provided.
Install the OCP 3.0 Ethernet adapter
Use this information to install the OCP 3.0 Ethernet adapter.
About this task
CAUTION:
Power off the server and disconnect all power cords from their power sources before performing this
procedure.
Attention:
• Read “Installation Guidelines” on page 185 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Note: If there is an OCP 3.0 Ethernet adapter installed, when the system is powered off but still plugged in to
AC power, system fans will continue to spin at a much lower speed. This is the system design to provide
proper cooling for the OCP 3.0 Ethernet adapter.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DqVplE36HIvdM_sq_Auw3U
• Youku: https://list.youku.com/albumlist/show/id_59643657.html
Procedure
Chapter 4. Hardware replacement procedures 279
To Next Page
Loading...
