Front I/O assembly
Use the section to understand the cable routing for the front I/O assembly.
Notes:
• The front I/O assembly varies by model. The illustration shows the cabling scenario for the front I/O
assembly on the right rack latch. The cable connection for the front I/O assembly on the front media bay is
the same.
• When routing the front I/O assembly cable, ensure that it is fixed on the upper frame of the cable retainer.
For details, refer to “Install the rack latches” on page 309.
Figure 16. VGA connector and front I/O assembly cable routing
From To
1 VGA cable on the left rack latch VGA connector on the system board
2 External diagnostics cable on the left rack latch External LCD connector on the system board
3 Front panel and front USB cable on the right rack latch Front I/O and front USB connectors on the system board
72 ThinkSystem SR650 V2Maintenance Manual
To Next Page
Loading...
