Step 6. (Optional) Remove the 7mm drive cage securing clip from the riser cage.
Figure 275. 7mm drive cage securing clip removal
After you finish
Remove the two 7mm backplanes from the 7mm drive cage. See “Remove the 7mm drive backplanes” on
page 344.
Remove the 7mm drive backplanes
Use this information to remove the 7mm drive backplanes.
About this task
Attention:
• Read “Installation Guidelines” on page 185 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DqVplE36HIvdM_sq_Auw3U
• Youku: https://list.youku.com/albumlist/show/id_59643657.html
Procedure
344 ThinkSystem SR650 V2Maintenance Manual
To Next Page
Loading...
