24 x NVMe front drive bays
This section provides cable routing information for the server model with 24 x 2.5-inch NVMe front drive 
bays.
•  “Retimer cards (24 x NVMe)” on page 113
•  “Switch cards (32 x NVMe)” on page 114
Retimer cards (24 x NVMe)
The following shows the cable connections for the 24 x 2.5-inch NVMe configuration with three retimer 
cards.
From To
Backplane 1: NVMe 0-1, 2-3
Onboard: PCIe 1, PCIe 2
Backplane 1: NVMe 4-5, 6-7
Retimer card on PCIe slot 1: C0, C1
Backplane 2: NVMe 0-1, 2-3
Retimer card on PCIe slot 2: C0, C1
Backplane 2: NVMe 4-5, 6-7
Onboard: PCIe 3, PCIe 4
Backplane 3: NVMe 0-1, 2-3
Onboard: PCIe 5, PCIe 6
Backplane 3: NVMe 4-5, 6-7
Retimer card on PCIe slot 4: C0, C1
Connections between connectors: 
1  ↔  1 ,  2  ↔  2 ,  3  ↔  3 , ...  n  ↔  n
Figure 56. Cable routing for the 24 x 2.5-inch NVMe configuration with three retimer cards
Chapter 3. Internal cable routing 113