Complete the parts replacement
Use this information to complete the parts replacement.
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
2. Properly route and secure the cables in the server. See Chapter 3 “Internal cable routing” on page 71.
3. If you have removed the top cover, reinstall it. See “Install the top cover” on page 378.
4. Reconnect external cables and power cords to the server.
Attention: To avoid component damage, connect the power cords last.
5. Update the server configuration if necessary.
• Download and install the latest device drivers:
http://datacentersupport.lenovo.com
• Update the system firmware. See “Firmware updates” on page 10.
• Use the Lenovo XClarity Provisioning Manager V3 to configure the RAID if you have installed or
removed a hot-swap drive, a RAID adapter, or the M.2 backplane and M.2 drive. For more
information, see:
https://sysmgt.lenovofiles.com/help/topic/lxpm_frontend/lxpm_v3_about.html
Chapter 4. Hardware replacement procedures 381
To Next Page
Loading...
