Lenovo ThinkSystem SR650 V2 - Rack Latches Replacement; Remove the Rack Latches

Rack latches replacement
Use this information to remove and install the rack latches.
Note: Depending on the model, the left rack latch might be assembled with a VGA connector and the right
rack latch might be assembled with the front I/O assembly.
• “Remove the rack latches” on page 306
• “Install the rack latches” on page 309
Remove the rack latches
Use this information to remove the rack latches.
About this task
Attention:
• Read “Installation Guidelines” on page 185 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
Note: If the rack latches are not assembled with a VGA connector or the front I/O assembly, you can
remove the rack latches without powering off the server.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DqVplE36HIvdM_sq_Auw3U
• Youku: https://list.youku.com/albumlist/show/id_59643657.html
Procedure
Step 1. If the server is installed with the security bezel, remove it first. See “Remove the security bezel” on
page 350.
306
ThinkSystem SR650 V2Maintenance Manual