Rear backplanes: 2 x 3.5-inch/4 x 3.5-inch/4 x 2.5-inch SAS/SATA
This topic provides cable routing information for the 12 x 3.5-inch SAS/SATA server model with a 2 x 3.5-
inch/4 x 3.5-inch/4 x 2.5-inch SAS/SATA rear drive cage.
Depending on the rear backplane and controller you use, refer to the specific configuration for cable routing
information.
Config.
Rear backplane Front backplane controller Rear backplane controller
“1” on page
168
2 x 3.5-inch SAS/SATA Onboard connectors Onboard connectors
“2” on page
169
4 x 3.5-inch/4 x 2.5-inch SAS/SATA Onboard connectors 8i RAID/HBA adapter
“3” on page
169
2 x 3.5-inch/4 x 3.5-inch/4 x 2.5-inch
SAS/SATA
One shared 16i RAID/HBA adapter
“4” on page
171
2 x 3.5-inch/4 x 3.5-inch/4 x 2.5-inch
SAS/SATA
16i RAID/HBA adapter Onboard connectors
“5” on page
171
2 x 3.5-inch/4 x 3.5-inch/4 x 2.5-inch
SAS/SATA
16i RAID/HBA adapter 8i RAID/HBA adapter
Chapter 3. Internal cable routing 167
To Next Page
Loading...
