• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DqVplE36HIvdM_sq_Auw3U
• Youku: https://list.youku.com/albumlist/show/id_59643657.html
Procedure
Step 1. Touch the static-protective package that contains the new backplane to any unpainted surface on
the outside of the server. Then, take the new backplane out of the package and place it on a static-
protective surface.
Step 2. Connect the cables to the backplane. See Chapter 3 “Internal cable routing” on page 71.
Step 3. Install the 3.5-inch drive backplane.
Note: Depending on the specific type, your backplane might look different from the illustration.
Figure 182. 3.5-inch drive backplane installation
a. Align the backplane with the chassis and lower it into the chassis. Then, put the backplane into
place with it leaning backward slightly.
b. Rotate the backplane to vertical position to ensure that the four hooks on the chassis pass
through the corresponding holes in the backplane. Then, slide the new backplane as shown
until it is secured into place.
Step 4. Connect the cables to the system board. See Chapter 3 “Internal cable routing” on page 71.
236
ThinkSystem SR650 V2Maintenance Manual
To Next Page
Loading...
