Figure 219. Hot-swap power supply filler removal
Step 3. Slide the new hot-swap power supply into the bay until it snaps into position.
Figure 220. Hot-swap power supply installation
Step 4. Connect the power supply unit to a properly grounded electrical outlet.
• For AC power supply units:
1. Connect one end of the power cord to the power connector on the power supply unit.
2. Connect the other end of the power cord to a properly grounded electrical outlet.
• For –48V DC power supply units:
1. Use a slotted screwdriver to loosen the 3 captive screws on the power supply terminal
block.
2. Check the polarity label on the power supply unit and each power cord.
Chapter 4. Hardware replacement procedures 295
To Next Page
Loading...
