Step 4. Route the bundle cable for I/O connectors on the right or left latches as shown. Then, install the
screws to secure the cable retainer.
Note: To avoid unnecessary damage to the bundle cable, ensure that it is routed and fixed on the
upper frame of the cable retainer.
Figure 236. Cable retainer installation
Step 5. Connect the cables to the system board. See Chapter 3 “Internal cable routing” on page 71.
After you finish
1. Install the ID label plate to the right rack latch as shown.
Figure 237. ID label plate installation
Chapter 4. Hardware replacement procedures 311
To Next Page
Loading...
