The rearwall brackets vary by server rear configurations. This topic uses the A1, B1, and C1 brackets as an
example for replacement illustration. The replacement procedure is the same for B2 and C2 brackets.
• “Remove a rearwall bracket” on page 325
• “Install a rearwall bracket” on page 327
Rearwall bracket matrix
Server rear
config.
Required rearwall brackets
Configuration
with 8 PCIe
slots
The server requires 3 rearwall brackets:
A1 rearwall bracket on the left
B1 rearwall bracket on the
middle
C1 rearwall bracket on the right
Configuration
with 4 x 2.5-
inch rear drives
The server requires 3 rearwall brackets:
A1 rearwall bracket on the left
B1 rearwall bracket on the
middle
C2 rearwall bracket on the right
Configuration
with 2 x 3.5-
inch rear drives
The server requires 2 rearwall brackets:
A1 rearwall bracket on the left
B1 rearwall bracket on the
middle
Configuration
with 8 x 2.5-
inch rear drives
The server requires 1 rearwall bracket:
Chapter 4. Hardware replacement procedures 323
To Next Page
Loading...
