Figure 289. System board installation
a. Insert the front end of the system board towards the chassis.
b. Lower the other end down into the chassis.
c. Slide the system board towards the rear of the chassis until it clicks into place. Ensure that rear
connectors on the new system board are inserted into the corresponding holes in the rear
panel.
Step 3. A new system board comes with half-height cable holders by default. If the old system board is
installed with full-height cable holders, remove them from the old system board and install them to
the new system board. See “Cable wall brackets replacement” on page 201.
After you finish
1. Install any components that you have removed:
• “Install a processor and heat sink” on page 301
• “Install a memory module” on page 269
• “Install the CMOS battery” on page 208
• “Install an internal CFF adapter” on page 239
• “Install a super capacitor on the chassis” on page 316
• “Install a system fan” on page 366
• “Install the system fan cage” on page 370
• “Install a PCIe adapter and riser assembly” on page 286
• “Install the rear 2.5-inch drive cage” on page 333
• “Install the rear 3.5-inch drive cage” on page 340
• “Install the OCP 3.0 Ethernet adapter” on page 279
2. Properly route and secure the cables in the server. See Chapter 3 “Internal cable routing” on page 71.
3. Install the air baffle or a middle drive cage if you have removed it. See “Install the air baffle” on page 198
or “Install the middle drive cage” on page 276.
4. Install the top cover. See “Install the top cover” on page 378.
5. Push the power supplies into the bays until they click into place.
6. Connect power cords to the server and turn on the server.
7. Update the server with the latest RAID firmware. See “Firmware updates” on page 10.
358
ThinkSystem SR650 V2Maintenance Manual
To Next Page
Loading...
