Lenze 8200 - Part E: Troubleshooting and fault elimination

Contents
8200SHB0199
vii
Part E
8 Troubleshooting and fault elimination 8-1...........................
8.1 Troubleshooting 8-1.................................................
8.1.1 Display at the controller 8-1..................................
8.1.2 Display at the operating module 8-1.............................
8.1.3 Maloperation of the drive 8-2.................................
8.2 Fault analysis with the history buffer 8-2..................................
8.3 Fault messages 8-2.................................................
8.4 Reset of fault messages 8-4...........................................
9 Maintenance 9-1..............................................
9.1 Maintenance services 9-1............................................
9.2 Service addresses 9-2...............................................
Part F
10 Network of several drives 10-1....................................
10.1 Function 10-1......................................................
10.2 Conditions for trouble-free network operation 10-2............................
10.2.1 Possible combinations 10-2...................................
10.2.2 Mains connection 10-3.......................................
10.2.2.1 Cable protection/cable cross-section 10-3..............
10.2.2.2 Mains choke/mains filter 10-3.......................
10.2.2.3 Controller protection 10-3..........................
10.2.3 DC-bus connection 10-4......................................
10.2.4 Fusesand cable cross-sections for a network of several drives 10-6.......
10.2.5 Protection innetworks of several drives 10-7.......................
10.3 Selection basics 10-9................................................
10.3.1 Conditions 10-9............................................
10.3.2 Selection example for 4 drives 10-12..............................
10.3.2.1 Supply only via controllers 10-12......................
10.3.2.2 Supply by means of 934Xsupply and feedback module 10-13.
10.4 Central supply 10-14..................................................
10.4.1 Central supply of 820X 10-14...................................
10.4.2 Central supply via 934X for 821X/822X/824X/93XX 10-15...............
10.5 Decentral supply 10-16................................................
10.5.1 Decentral supply for 820X 10-16.................................
10.5.2 Central supply for 821X/822X/824X/93XX/934X 10-17.................
See also table of contents of the attached Operating Instructions
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com