Configuration
8200SHB01997-4
7.2 Structure of the operating program
The operating program has three program levels: operating level, code level, and
parameter level. The controller parameters are set in the code level and the
parameter level.
FIG 7-2 Flow chart for parameter setting
7.2.1 Operating level
- The controller is in the operating level after mains connection.
- You can see the switch-on display (C004).
- You can change to the code level by pressing the key PRG.
7.2.2 Code level
- In the code level you select a code by pressing ▲ or ▼.
- Change to the parameter level by pressing the key SH.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
