Safety information
8200SHB01992-2
2.2 Layout of the safety information
- All safety information has a uniform layout:
- The icon characterises the type of danger.
- The signal word characterises the severity of danger.
- The note describes the danger and suggests how to avoid the danger.
Signal word
Note
Icons used Signal words
Warning of
danger to
persons
Wa rni ng of
hazardous
electrical voltage
Danger! Wa rn s of impending dangeU .
Consequences if disregarded:
Death or severe injuries.
Wa rni ng of a
general danger
Warning! Wa rns of potential, very hazardous situations.
Possible consequences if disregarded:
Death or severe injuries.
Caution! Wa rns of potential, hazardous situations .
Possible consequences if disregarded:
Light or minor injuries.
Warning of
damage to
material
Stop! Wa rns of potential damage to material .
Possible consequences if disregarded:
Damage of the controller/drive system or its environment
.
Other notes Note! Designates a general, useful note.
If this note is observed, handling of the controller/drive
systemis easier.
2.3 Residual hazards
Operator’s safety After mains disconnection, the power terminals U, V, W and +U
G
,-U
G
remain live for at least 3 minutes.
-
Before working on the controller, check that no voltage is applied to the power terminals.
Protection of devices Cyclic connection and disconnection of the controller supply voltage at L1, L2, L3 or + U
G
,+U
G
may
overload the internal input current limit.
-
Allow at least 3 minutes between disconnection and reconnection.
Overspeeds Drive systems can reach dangerous overspeeds (e.g. setting high field frequencies for motors and
machines which are not suitable):
-
The controllers do not offer any protection against these operating conditions. Use additional
components for this.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
