Preface and general information
8200SHB0199
1-9
EC Declaration of Conformity ’95 for the purpose of the EC
Directive
on Electromagnetic Compatibility (89/336/EEC)
amended by: First Amendment Directive (92/31/EEC)
CE Mark Directive (93/68/EEC)
820X/821X/822X/824X controllers cannot be driven in stand-alone operation for
the purpose of the Regulation about Electromagnetic Compatibility (EMVG of
9/11/92 and 1. EMVGÄndG of 08 August, 1995). The EMC can only be verified
when the controller is integrated into a drive system.
Lenze GmbH & Co KG, Postfach 10 13 52, D-31763 Hameln
declares that the described ”CE-typical drive systems” with the controllers of the
types 820X/821X/822X/824X comply with the above mentioned EC Directive.
The conformity evaluation is based on the working paper of the product standard
for drive systems:
IEC 22G-WG4 5/94 EMC product standard including specific test methods for power drive systems”
Generic standards considered:
Generic standard
EN 50081-1 /92 Generic standard for the emission of noise
Part 1: Residential area, commercial premises, and small businesses
EN 50081-2 /93
(used in addition to the
requirements of IEC 22G)
Generic standard for the emission of noise
Part 2: Industrial premises
The emission of noise in industrial premises is not limited in IEC 22G.
prEN 50082-2 3/94 Generic standard for noise immunity
Part 2: Industrial premises
The requirements of noise immunity for residential areas were not considered
since they are less strict.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
