Lenze i950 - Page 126

Parameter
Address Name / seng range / [default seng] Info
0x5051:064 Eecve velocity for diameter
calculaon
•
R
ead only: x.xxxx mm/s
0x5051:098 Vp of diameter idencaon
1.00 ... [100.00] ... 100.00
%
0x5051:099 Diameter idencaon velocity
-214748.3648 ... [100.0000] ... 214748.3647 mm/s
0x5051:100 Diameter idencaon acceleraon
1.00 ... [2000.00] ... 10000.00 mm/s²
0x5051:101 Diameter idencaon deceleraon
1.00 ... [2000.00] ... 10000.00 mm/s²
0x5051:102 Diameter idencaon jerk
1.00 ... [2000.00] ... 10000.00 mm/s³
0x5051:103 Required calculaon cycles for diameter idencaon
1 ... [2] ... 65535
0x5051:104 Max. dancer posion diameter idencaon
1.00 ... [50.00] ... 100.00 %
0x5052:189 Eecve actual dancer posion
•
R
ead only: x.xx %
0x5052:195 Threshold for upper dancer posion
0.00 ... [95.00] ... 2000.00
%
0x5052:196 Threshold for lower dancer posion
-2000.00 ... [-95.00] ... 0.00 %
0x5052:200 Stored material length in dancer
-214748.3648 ... [0.0000] ... 214748.3647 mm
Conguring the "Winder Dancer" TA
Diame
ter esmaon before dancer moon
126