Lenze i950

7.2.2 Dening the material feeding
Bit 28 of parameter Con
trol signals is used to dene whether the material is fed to the winder
from above or below. See the diagram below. 0x5050:010 Bit 28
Winding with material from above. Bit 28 = TRUE Winding with material from below. Bit 28 = FALSE
V
V V
V
V
V V
V
The basic adjustment of the winder sha to the material ow takes place via the Motor
mounng direcon. 40x500A:035
Conguring the "Winder Dancer" TA
Con
trol sengs
Dening the material feeding
101