Lenze i950

13.6 Opons for opmising the control loops
The opon to be selected depends on the respecve applicaon. Depending on the selected
opon,
dierent procedures become acve and thus dierent parameter groups are inu-
enced:
•
Ra
ted motor data
•
Inverter characterisc
•
Motor equivalent circuit diagram data
•
Motor controller sengs
•
Speed controller sengs
•
Posion controller sengs
13.6.1 Automac motor
idencaon (energized)
Parameter
Address Name / seng range / [default seng] Info
0x2832 Motor idencaon status
•
R
ead only
Display of the status for the automac idencaon of the motor
parameters.
Parameters for interacon with engineering tools.
Bit 0 Idencaon enabled Parameters for interacon with engineering tools.
Bit 1 Idencaon acve
Bit 2 Idencaon completed
Bit 3 Idencaon failed
Conguring the motor control
Opons for opmising the control loops
Automac motor idencaon (energized)
255