Lenze i950

Address Designaon Default seng Data type Factor A M
0xA680:012 Systembus input data: Systembus data input 12 0 U32 1 X ●
0xA680:013 Systembus input data: Systembus data input 13 0 U32 1 X ●
0xA680:014 Systembus input data: Systembus data input 14 0 U32 1 X ●
0xA680:015 Systembus input data: Systembus data input 15 0 U32 1 X ●
0xA680:016 Systembus input data: Systembus data input 16 0 U32 1 X ●
0xE901:002 FSoE communicaon Parameters: Safety address - (Read only) U16 1 X
0xF980:001 Safety address: FSoE address - (Read only) U16 1 X
0xF980:002 Safety address: Safety address - (Read only) U16 1 -
* Default seng depending on the size.
21.2 Glossary
Abbreviaon Meaning
AIE Acknowledge In Error, error acknowledgement
AIS Acknowledge In Stop, restart acknowledgement
OFF state Triggered signal status of the safety sensors
CCF Common Cause Error (also β-value)
EC_FS Error Class Fail Safe
EC_SS1 Error-Class Safe Stop 1
EC_SS2 Error-Class Safe Stop 2
EC_STO Error-Class Safe Torque O Stop 0
ON − status Signal status of the safety sensor in normal operaon
FIT Failure In Time, 1 FIT = 10-9 Error/h
FMEA Failure Mode and Eect Analysis
FSoE Fail Safe over EtherCAT, Safety over EtherCAT
GSDML Device descripon le with PROFINET-specic data for integrang the conguraon soware of a
PR
OFINET controller.
HFT Hardware Failure Tolerance
Cat. Category in accordance with EN ISO 13849-1
OSSD Output Signal Switching Device, tested signal output
PELV Protecve Extra Low Voltage
PL Performance Level (in accordance with ISO 13849)
PM Plus−Minus − switched signal paths
PP Plus−Plus − switched signal paths
PS PROFIsafe
PWM Pulse width modulaon
SCS Safe Crawling Speed
SD−In Safe Digital Input, safe input
SD−Out Safe Digital Output, safe output
SELV Safety Extra Low Voltage
SFF Safe Failure Fracon
SIL Safety Integrity Level in accordance with IEC 61508
Appendix
Glossar
y
493