EasyManua.ls Logo

Lenze i950

Lenze i950
496 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7.15.1.2 Monitoring based on the dancer posion
In
addion to web monitoring, which operates on the basis of the direcon of the diameter
change, web breaks can also be considered the most likely cause of the dancer reaching the
lower limit posion during operaon in the case of dancer posion-controlled winders.
The method on which the web break monitoring is based is dened in the parameter Method
of web break monitoring. 40x5051:073
Method of web break monitoring 0x5051: 073 Bit Status Informaon
0 Unexpected change in
diame
ter direcon + dancer
in dancer end posion
18 TRUE A web break is detected
when the Eecve actual
dancer posion falls below
the Threshold for lower
dancer posion when the
dancer control is acve.
Eecve actual dancer
posion 0x5052:189
Threshold for lower
dancer posion
0x5052:196
The dancer r
eaching the
lower limit posion dur-
ing operaon indicates a
w
eb break.
Alternavely, the web
break monitoring can
also be based on detect-
ing changes in the diame-
ter. When the diameter
changes in a direcon dif-
ferent to the one expec-
ted, web break monitor-
ing is triggered.
1
Dancer in dancer end posi-
on
18
TRUE
A web break is detected
when the Eecve actual
dancer posion falls below
the Threshold for lower
dancer posion when the
dancer control is acve.
Eecve actual dancer
posion 0x5052:189
Threshold for lower
dancer posion
0x5052:196
The dancer r
eaching the
lower limit posion dur-
ing operaon indicates a
w
eb break.
Alternavely, the web
break monitoring can
also be based on detect-
ing changes in the diame-
ter. When the diameter
changes in a direcon dif-
ferent to the one expec-
ted, web break monitor-
ing is triggered.
2 Unexpected change in
diameter
- - This funcon is described
under web break monitor-
ing based on a change in
diameter direcon.
The web break monitoring is acvated by seng bit 24 = TRUE in the parameter Con
trol sig-
nal. 40x5050:010 Bit 24
When a web break has been detected, bit 24 = TRUE is set in the parameter Status signal.
40x5050:110 Bit 24
Conguring the "Winder Dancer" TA
Monit
oring
Web break monitoring
146

Table of Contents

Other manuals for Lenze i950

Related product manuals