Lenze i950 - Page 119

Address Name / seng range / [default seng] Info
0x5051:009 Actual line velocity
•
R
ead only: x.xxxx mm/s
The parameter is resolved with 4 decimal posions. The parameter has
the unit [mm/s].
0x5051:016 Min. reel diameter
1.0000 ... [50.0000] ... 10000.0000 mm
0x5051:017 Max. reel diameter
1.0000 ... [180.0000] ... 10000.0000 mm
0x5051:033 Eecve set speed
•
Read only: x.xx rev/s
0x5051:064 Eecve velocity for diameter calculaon
•
R
ead only: x.xxxx mm/s
0x5051:065 Start diameter source
0 Parameter Start diameter source from parameter
St
art diameter source from parameter
1 External Start diameter source from external
Start diameter source from external (eldbus/system bus)
0x5051:066 Start diameter
1.0000 ... [100.0000] ... 10000.0000 mm
0x5051:067 External start diameter
•
Read only: x.xxxx mm
0x5051:068 Start diameter adapted via characterisc curve
•
Read only: x.xxxx mm
0x5051:069 Source of line velocity for diameter calculaon
false Parameter Line speed source from parameter
true Addional circumference speed Line speed source from external
0x5051:070 Number of revoluons for standard diameter calcula-
on
0.00 ... [1.00] ... 21474836.47 rev
0x5051:071 Number of revoluons for fast diameter calculaon
0.00 ... [0.10] ... 21474836.47 r
ev
0x5051:074 Filter me actual diameter
0.000 ... [0.050] ... 2147483.647 s
0x5051:075 Set diameter
•
Read only: x.xxxx mm
0x5051:096 Actual diameter
•
Read only: x.xxxx mm
The parameter is resolved with 4 decimal posions. The parameter has
the unit [mm].
0x5052:189 Eecve actual dancer posion
•
R
ead only: x.xx %
0x5052:200 Stored material length in dancer
-214748.3648 ... [0.0000] ... 214748.3647 mm
0x5052:201 Filter me dancer movement
0.001 ... [0.005] ... 0.010
s
Conguring the "Winder Dancer" TA
Diame
ter calculaon
119