Lenze i950 - Page 118

ABS
s
*(-1)
d
v
n
=
´ p
n
v
d
Min. diameter
0x5051:016
Max. diameter
0x5051:017
Min diameter reached
0x5050:110 Bit 23
Max diameter reached
0x5050:110 Bit 22
Diameter hold active
0x5050:110 Bit 21
Pt1 filt.tim.act.diam
0x5051:074
Actual diameter
0x5051:096
Resulting speed set value
0x5051:033
In: Set diameter
0x5050:011
Ai1: percent
value scaled
0x2DA4:005
Ref. Diameter
AnalogIn1
0x5020:013
Actual velocity
0x500B:011
Actual line velocity
0x5051:009
Unwind operation
0x5050110 Bit 17
Dancer act.
position
filtered
0x5052:189
Stored material
length dancer
0x5052:200
Source set diameter
0X5020:022
Start diameter set value
0x5051:066
Start diam. set val. Extern
0x5051:067
Source set diameter CM
0x5051:065
Actual diameter set value
0x5051:075
Source line velocity Dcalc
0x5051:069
Regular diam. calc distance 0x5051:070
Red.diam.calc distance 0x5051:071
MoveComp: PT1 filter time
0x5052:201
Load diameter
0x5050:010 Bit 22
Diameter adaption curve
Fig. 44: Diameter
calculaon signal ow
Parameter
Address Name / seng range / [default seng] Info
0x2DA4:005 Diagnoscs of analog input 1: Scaled percent value
•
R
ead only: x.xx %
Current value of the analog input is resolved with 2 decimal places.
Display of the actual value at the analog input, scaled with the following
parameters:
•
Minimum value for scaling. 40x2636:013
•
Maximum value for scaling. 40x2636:014
0x500B:011 Actual velocity
•
R
ead only
The current speed value is resolved with 4 decimal posions.
0x5020:013 Reference diameter analog input 1
0.0000 ... [1000.0000] ... 214748.3647 mm
0x5020:022 Set diameter source
0 External
1 Analog input 1
0x5050:011 Set diameter (control word 2)
0.0000 ... [0.0000] ... 214748.3647 mm
The value of the external start diameter is specied in [mm]. It has 4
decimal posions.
Conguring the "Winder Dancer" TA
Diame
ter calculaon
118