Lenze i950

7.3 Source
selecon for control signals
There are a number of sources available from which to choose the master value input. The
source must be selected in the parameter Line velocity source. 40x5020:020
The following sources can be selected:
•
External line speed selecon [0]
•
Applicaon feedback selecon [1]
•
Sync. master value selecon [3]
This chapter describes how to select the sources for the signals required for commissioning.
4Sour
ce for line speed ^ 103
4Source for circumferenal speed ^ 104
4Sour
ce for start diameter ^ 104
4Source for set dancer posion ^ 105
4Source for actual dancer posion ^ 105
4Sour
ce for dancer control correcon value ^ 106
When changing the source, the inverter must be inhibited.
Conguring the "Winder Dancer" TA
Sour
ce selecon for control signals
102