EasyManua.ls Logo

Lenze i950

Lenze i950
496 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7.4.2 Status signals
P
arameter
Address Name / seng range / [default seng] Info
0x5050:110 Status signals
0x00000000 ... [0x00000000] ... 0xFFFFFFFF
Bit 0 Ready for
operaon The axis is ready to be switched on.
Bit 1 Status signal bit 1 The status bit can be assigned a funcon status.
Bit 2 Operaon enabled The axis has been enabled.
Bit 3 Fault A drive error is displayed.
Bit 4 Status signal bit 4 The status bit can be assigned a funcon signal.
Bit 5 Applicaon quick stop acve Quick stop has been triggered.
Bit 6 Manual jog acve Manual operaon is acvated.
Bit 7 Warning The drive warning is acvated.
Bit 8 Halt acve Stop has been triggered.
Bit 9 Status signal bit 9 The status bit can be assigned a funcon status.
Bit 10 Status signal bit 10
Bit 11 Limitaon acve
Bit 12 Standsll The drive is at standsll.
Bit 13 Direcon of rotaon inverted The direcon of rotaon is inverted.
Bit 14 Brake opened The holding brake is released.
Bit 15 STO acve Safe Torque O is acvated.
Bit 16 Winder syncronized to line The winder moves synchronously with the line speed.
Bit 17 Unwinding operaon Unwinder operaon is acvated.
Bit 18 Dancer control acve Dancer-regulated operaon is acvated.
Bit 19 Status signal bit 19 The status bit can be assigned a funcon status.
Bit 20 Status signal bit 20
Bit 21 Diameter hold acve The diameter is being maintained.
Bit 22 Max. diameter reached The maximum diameter has been reached.
Bit 23 Min. diameter reached The minimum diameter has been reached.
Bit 24 Web break A web break has been detected.
Bit 25 Dancer in max. posion The dancer is at the maximum posion.
Bit 26 Dancer in min. posion The dancer is at the minimum posion.
Bit 27 Status signal bit 27 The status bit can be assigned a funcon status.
Bit 28 Dancer in set
posion The dancer is in the setpoint posion.
Bit 29 Ready for moon The line speed is being limited.
Bit 30 Internal ramp or idencaon
acve The internal ramp or the idencaon is acve.
Bit 31 Status signal bit 31 The status bit can be freely assigned a funcon status.
Conguring the "Winder Dancer" TA
In
terface
Status signals
109

Table of Contents

Other manuals for Lenze i950

Related product manuals