Lenze i950 - Page 393

Saving oscillogram in le
The reuse of a saved conguraon is only reasonable for inverters of the same
type (e. g. i950 in
verters), as otherwise due to a scaling of the oscilloscope chan-
nels that is not adapted, incorrect values are displayed!
Aer selecng the parameters to be recorded from the selecon list of the signal sources and
making any further necessary sengs, you can save this conguraon and the recording if
already carried out on the Engineering PC for a later reuse.
How to save the oscillogram:
1.Click the symbol in the toolbar. the "Save oscillogram" dialog box is displayed.
2.Dene a name in the Name input eld of the oscillogram to be saved.
3.Click the "Export to le" buon.
4.Specify the folder and le name for the oscillogram be stored in the Save as dialog box.
5.Click the Save buon. The dialog box is closed.
The current oscillogram is saved.
Loading oscillogram / conguraon from le
The reuse of a saved conguraon is only reasonable for inverters of the same
type (e.
g. i950 inverters), as otherwise due to a scaling of the oscilloscope chan-
nels that is not adapted, incorrect values are displayed!
Data
sets/conguraons which have already been saved can be reloaded into the oscilloscope
any me, e.g. for the overlay funcon.
How to load an oscillogram or a conguraon:
1.Click the symbol in the oscilloscope toolbar. The "Load oscillogram" dialog box is displayed.
2.Press the Search... buon.
3.Select the le to be imported within the desktop environment from the Open dialog box.
4.If the oscillogram is to be used as conguraon, select the As conguraon... opon.
5.Click the Open buon. The dialog box is closed.
The selected oscillogram or conguraon is imported.
Closing the oscillogram
You can close an open OFFLINE oscillogram again any me.
•
Aer an oscillogram is closed, it is no longer available in the oscillogram list eld. The oscil-
loscope changes automacally to the display of the ONLINE oscillogram.
•
If the closed oscillogram was included in the MERGE oscillogram, its channels will be
removed from the MERGE oscillogram.
•
Go to the oscilloscope toolbar and click the symbol to close the currently displayed OFF-
LINE oscillogram.
Overlay funcon
The overlay funcon serves to overlay several characteriscs from the currently loaded data
sets, e.g. to compare signal characteriscs from dierent recordings.
•
If tw
o or more oscillograms are loaded in the oscilloscope, e.g. the ONLINE oscillogram and
an oscillogram that was previously loaded into a le, a "MERGE" oscillogram will be auto-
macally available in the "Oscillogram" list eld.
•
If the merge oscillogram is selected, the desired characteriscs to be overlaid or compared
c
an be selected from the loaded oscillograms in the Vercal channel sengs group eld.
•
If an ONLINE oscillogr
am is used in the MERGE oscillogram, an update is carried out in the
MERGE oscillogram in the case of a renewed recording.
•
Removing variables from an OFFLINE or ONLINE oscillogram causes the characteriscs in
the MER
GE oscillogram to be deleted.
Addional
funcons
Oscilloscope funcon
393