EDS94ARNExxxx EN 2.3 - 06/2014 L 127
9400 regenerative power supply module | Parameter setting
"CAN on board" system bus
Parameter data transfer
Meaning of the error code
Error code Explanation
0x0503 0000 Toggle bit not changed.
0x0504 0000 SDO protocol expired.
0x0504 0001 Invalid or unknown client/server command specifier.
0x0504 0002 Invalid block size (only block mode).
0x0504 0003 Invalid processing number (only block mode).
0x0504 0004 CRC error (only block mode).
0x0504 0005 Not sufficient memory.
0x0601 0000 Object access not supported.
0x0601 0001 Attempt to read a write-only object.
0x0601 0002 Attempt to write to a read-only object.
0x0602 0000 Object not listed in object directory.
0x0604 0041 Object not mapped to PDO.
0x0604 0042 Number and length of objects to be transferred longer than PDO length.
0x0604 0043 General parameter incompatibility.
0x0604 0047 General internal device incompatibility.
0x0606 0000 Access denied because of hardware error.
0x0607 0010 Unsuitable data type (unsuitable service parameter length).
0x0607 0012 Unsuitable data type (service parameter length exceeded).
0x0607 0013 Unsuitable data type (service parameter length not long enough).
0x0609 0011 Subindex does not exist.
0x0609 0030 Parameter value range exceeded.
0x0609 0031 Parameter values too high.
0x0609 0032 Parameter values too low.
0x0609 0036 Maximum value falls below minimum value.
0x0800 0000 General error.
0x0800 0020 Data cannot be transferred/stored for application.
0x0800 0021 Data cannot be transferred/stored for application due to local control.
0x0800 0022 Data cannot be transferred/stored for application due to current device state.
0x0800 0023 Dynamic generation of object directory failed or no object directory available (e.g. object
directory generated from file, generation not possible because of a file error).
To Next Page
Loading...
