9400 regenerative power supply module | Parameter setting
Device interface
Device commands
50 L EDS94ARNExxxx EN 2.3 - 06/2014
4.1.11 Reset program
The C00002
= "33: Reset program" device command serves to reset the application
program in the regenerative power supply module.
All variables are reset to their initialisation values.
The situation corresponds to the start of a new program loaded into the control system
(cold start).
Possible status displays for this device command
Related device commands
Delete program
( 51)
Restart program
( 52)
Status (C00003) Meaning
2196738 Device command in process
2162688 Device command executed successfully
2162689 General fault
To Next Page
Loading...
