Lenze L-force 9400 Series Software Manual

EDS94ARNExxxx EN 2.3 - 06/2014 L 275
9400 regenerative power supply module | Parameter setting
Parameter reference
Parameter list | C00003
C00003
C00004
C00005
C00006
C00007
Parameter | Name:
C00003 | Device command status
Data type: UNSIGNED_32
Index: 24572
d
= 5FFC
h
Display of the number/state of the device command last executed (C00002).
• The number of the command stands in the upper 16 bits (for the meaning of the number, see code C00002
).
• The result of the command stands in the lower 16 bits.
Note:
Before switching off the supply voltage after a device command has been executed, check via the status display in
C00003
that the device command has been executed successfully!
The meaning of the status display in C00003
can be obtained from the subchapter for the corresponding device
command in the "Device commands
" chapter.
Display range (min. value | unit | max. value)
0 4294967295
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C00004 | Service password
Data type: UNSIGNED_32
Index: 24571
d
= 5FFB
h
Service code to unlock protected device commands (C00002).
Setting range (min. value | unit | max. value) Lenze setting
0 4294967295 0
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C00005 | Application selection
Data type: INTEGER_32
Index: 24570
d
= 5FFA
h
Selecting the application
• Use the device command C00002
="5" to activate the selected application.
Setting range (min. value | unit | max. value) Lenze setting
-1 16 0
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C00006 | Selected control scheme
Data type: UNSIGNED_8
Index: 24569
d
= 5FF9
h
Selection list (display only)
1 Modus: closed loop control
2 Modus: open loop control
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C00007 | Active application
Data type: INTEGER_32
Index: 24568
d
= 5FF8
h
Display range (min. value | unit | max. value)
-2147483648 2147483647
 Read access  Write access  CINH  PLC STOP  No transfer

Lenze L-force 9400 Series Specifications

General

Brand	Lenze
Model	L-force 9400 Series
Category	Servo Drives
Language	English