EDS94ARNExxxx EN 2.3 - 06/2014 L 67
9400 regenerative power supply module | Parameter setting
Device interface
Device commands
4.1.27 CAN on-board: Identify node
The C00002
= "95: CAN on-board: Identify node" device command serves to identify the
nodes connected to the CANopen system bus interface of the regenerative power supply
module ("CAN on board").
The result of the CAN bus scan is displayed in C00393
.
Tip!
For detailed information about the "CAN on board" CANopen system bus interface,
please see the "CAN" Communication Manual.
Possible status displays for this device command
Related device commands
CAN on-board: Reset node
( 63)
CAN on-board: Pred.Connect.Set
( 65)
Status (C00003) Meaning
6259970 Device command in process
6225920 Device command executed successfully
6225921 General fault
To Next Page
Loading...
