Lenze L-force 9400 Series Software Manual

EDS94ARNExxxx EN 2.3 - 06/2014 L 77
9400 regenerative power supply module | Parameter setting
Device interface
Device commands
4.1.35 Prepare firmware update
 Only possible when the controller is inhibited and the application has been stopped.
Possible status displays for this device command
 Note!
For Lenze service only!
The C00002
= "10000: Prepare firmware update" device command serves to set
the regenerative power supply module to the firmware update mode to carry
out a possibly required update of the firmware using the corresponding
software.
Status (C00003) Meaning
655394050 Device command in process
655360000 Device command executed successfully
655360001 General fault

Lenze L-force 9400 Series Specifications

General

Brand	Lenze
Model	L-force 9400 Series
Category	Servo Drives
Language	English