EDS94ARNExxxx EN 2.3 - 06/2014 L 43
9400 regenerative power supply module | Parameter setting
Device interface
Device commands
4.1.5 Save selected application
After mains switching, the regenerative power supply module always loads the default
start application from the memory module, even if a different application has been active
before.
The device command C00002
= "7: Save selected application" can be used to define the
active application as start application.
[4-4] "Save selected application" function
When this device command is executed, the parameter set is also saved automatically.
The number of the currently active application is displayed in C00007
.
Possible status displays for this device command
Related device commands
Activate application
( 42)
Start application
( 48)
Stop application
( 49)
* In this example the active application 2 is defined as start application
PS
9400
RAM
Firmware Application 2*
PS
Application 3
Memory module MM
Application 1
Application 2*
PS
Status (C00003) Meaning
492802 Device command in process
458752 Device command executed successfully
458753 General fault
To Next Page
Loading...
