9400 regenerative power supply module | Parameter setting
"CAN on board" system bus
Possible settings via DIP switches
102 L EDS94ARNExxxx EN 2.3 - 06/2014
6.2.2 Setting the baud rate
The baud rate can be set via code C00351
or via the DIP switches a ... d:
Tip!
The baud rate resulting from the setting of the DIP switches at the last mains
switching is displayed in C00349/2
.
Switch positions Baud rate
d c b a
OFF ON ON OFF 10 kbps
OFF ON OFF ON 20 kbps
OFF OFF ON ON 50 kbps
OFF OFF ON OFF 125 kbps
OFF OFF OFF ON 250 kbps
OFF OFF OFF OFF 500 kbps
ON ON ON OFF 800 kbps
OFF ON OFF OFF 1 Mbps
OFF ON ON ON Automatic detection
Note!
Switch off the voltage supply of the standard device and then on again to
activate changed settings.
To Next Page
Loading...
